Jump to content

Don't hear takes during cycle recording.


IvanCh
Go to solution Solved by David Nahmani,

Recommended Posts

If you can live with one cycle run of not recording anything in between two recordings, and using 2-3 key commands, you could do the following:

1) select an audio track, open live loops grid, make sure no cell is selected

2) In the cell inspector, which should now show "Audio Defaults", set the desired loop length (and set cell length to the same value), set Rec-Length to "Cell Length" and At Rec-End to "Play" (you may have to click on the little ">" signs before "Play From:" and "Recording:" to reveal those parameters)

3) Right-click on a cell, choose "record into cell" (you may want to do this with Count-in active)

4) Record your audio. Cell will change from Record to Play mode after the chosen Cell Length

5) while the recorded cell is playing, press Cmd-D to duplicate the audio track. This will also select the newly created track.

6) you may want to disable count-in now by pressing Shift-K

7) as soon as playback is somewhere in the last bar of the already recorded cell, press Option-R to start cell recording again

8) repeat from step 4)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...