Jump to content

Best service ENGINE 2 routing


deathmetalmaster

Recommended Posts

Hello,

 

 

I recently switched over to logic from Reaper specifically for working with midi and I must say, it's a vast improvement in many ways. I am very familiar with how to set up proper routing using kontakt as far as routing one instance of kontakt to multiple channels. I am, however, unfamiliar with doing the same for engine 2. are there any experts who could direct me to, or walk me through the steps which I need to do? One thing in particular that seems a bit different to me is that each stereo track in Engine 2 only has outs that say: Stereo1, stereo 2, stereo 3, etc. while in Kontakt, each track says : Stereo 1/2, Stereo 3/4, stereo 5/6, etc. Should each track within engine be routed 1, 2, 3, or should it be done 1, 3, 5, 7, etc? Engine does not provide much in the way of tutorials. It would be greatly appreciated if someone could help me figure this out.

 

thanks

Link to comment
Share on other sites

  • 5 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...